Fejfar Technology Blog: An Alternate Perpetual Motion Electric Generator

Fejfar Technology Blog: An Alternate Perpetual Motion Electric Generator: The Alternate Propetual Motion Electric Generator, described below, is Copyrighted and Patented below: 1. You get a water pressure pump, t...

An Alternate Perpetual Motion Electric Generator

The Alternate Propetual Motion Electric Generator, described below, is Copyrighted and Patented below:

1. You get a water pressure pump, typically used for a water pressure gun, and attach
then water pressure hose out to a card turbine box, which does not need to be air tight.

2. You get the water pressure hose and put in a joint which produces two hoses out
and place one hose on the side near the top, and the other hose on the top on the
other side, each about 4 inches in.

3. You then plug the water pressure pump electric motor into a load transfer switch,
with the other two ends in which one is plugged into a small electric generator, and the
other is plugged into the Electric Generator Head which is powered by the water card
turbine.

4. And to clarify, the water pressure powered water card turbine turns an internal
drive shaft which in coupled to the drive shaft on a Electric Generator Head.
At the bottom of the water pressure turbine box there is a drain hole and hose
which puts the used water back into the water tank from which the water pressure
pump draws water. There is a float valve on the water tank which allows water from
a water line into the tank to keep it full, but does not allow it to overflow.

5. When the water pressure pump and turbine turns the Electric Generator Head, one fourth of the electricity is recycled to power the water pump and the other three quarters of electricity is available for use or sale.

Perpetual (C)Copyright and (P)Patent by Anthony J. Fejfar and Neothomism, P.C. (PA) and The American People and The People of God, as a Public Domain Copyright and Patent.

How to Artifically Make Industrial Diamonds

It appears that Industrial Diamonds can be artificially made by combining the following materials and then heat the composite of these materials at a high temperature. The materials list for making Industrial Diamonds is:
1. Silver ore
2. Iron ore
3. copper ore
4. granite dust

By the way, it appears that the Industrial Diamonds referred to above can be used to cut and grind titanium for use in paint and bullet proof glass, etc. Recall, that titanium is made from combining and smelting together, iron ore, silver ore, and copper ore.

Perpetual (C)Copyright and (P)Patent by Anthony J. Fejfar, CEO of Neothomism, P.C. (PA) and the aforesaid Neothomism, P.C. (PA) and the American People as a
Public Domain Copyright and Patent.

Fejfar Technology Blog: Fejfar Induction Coil Battery for a PC Computer

Fejfar Technology Blog: Fejfar Induction Coil Battery for a PC Computer: The basic design for an the Fejfar Induction Coil Battery is as follows: You take a coil of dual wire insulated wire such as ordinary two st...

Fejfar Induction Coil Battery for a PC Computer

The basic design for an the Fejfar Induction Coil Battery is as follows: You take a coil of dual wire insulated wire such as ordinary two strand lamp cord and at one end of the 100 foot wire coil you connect the two end wires with a 75 ohm resistor, at the other end of the coil you take the two wire leads and attach them in parallel to the main DC Power terminals of the computer just after the AC to DC transformer. You set this up so that even when the PC Computer is Off but plugged in, the Fejfar Coil Induction Battery is still connected. In fact, you could have several of these inside the PC Computer Case. You can also parallel this with Salt Water Core Batteries. The result should be that you will have at least a 5 hour use of your computer even if the power is out. Even longer if you put the computer on standby. Also, if you put in a floating ground resistor on the return DC line, in conjunction with one way diodes, then the result is a loop recyling through the primary of circuit of the Computer of must of the electricity. The result is that, once charged, the computer may be able to run on its own for weeks at a time or more.
Perpetual (C)Copyright and (P)Patent by Anthony J. Fejfar and Neothomism, P.C. (PA)

How to Make a Simple AC Electric Generator

As a Hobby Project, or a 4-H Project or a Boy Scout Project, or for actual use on a farm, for example, you can build your own AC electric generator. You may need to make some alterations to suit your individual needs, but the basic design is valid. You start by cutting a 1' diameter PVC plastic pipe to a length of 3 feet. You then put a wooden dowel inside the PVC pipe to reinforce it. You then buy a large spool of 16 gauge wire with plastic covering (American gauge standard) of 100 foot length. You put approximately 2 feet of slack in the wire on one side and begin wrapping the wire so that the wire is spooled onto the PVC pipe in the middle of the pipe across of 1 and 1/2 foot length, leaving 2 feet of slack wire at the other end of the pipe. You then strip the wire at each end, removing the plastic and wire the slack wire so that the wire is separated into 3 different lines and firmly attache to the pipe at equal distances. You then get some 2 inch by 6 inch lumber and make two 3 foot high posts with a 1 inch hole drilled in each, which you then grease. The posts must be firmly attached to a base. You then place the ends of the pipe through the holes at each end. You then use a 3/4 inch plywood base to connect the two posts at the bottom. You then build table shelf at two inches below the wire wrappings of the pipe. You then get two large chunks of iron and run DC volts through the iron to polarize the electrons in the iron and thus magnetize them. If you cannot use DC electricity to do this, then you can simply rub the iron bars in the same direction over and over again to magnetize them. Then, you can start by putting a hand crank at the one end of the pipe. Also, you must get two pieces of copper sheeting approximately 1/16 inch thick and 6 inches long, and 1 inch wide and attach each to a wooden post which is attache to the table and let each sheeting piece overlap the top of the pipe where the 3 copper wires from the wire spool coil will aternatively keep in contact with the copper sheeting strip as the pipe with the coil spool is turned. You then attach a wire core or wrapped romex wire to each of the respective posts and then hook each end of the wires to a heating coil to test the generator. You then turn the pipe with the hand crank to test it, and later it could be turned by an ox with a wooden turnstyle and wooden spoke gears, later with a gasoline engine.
Perpetual (C)Copyright and (P)Patent by Anthony J. Fejfar and Emmanuel J. Fejfar and Joshua A. Fejfar and Neothomism P.C. (PA) and the American People as a Perpetual Public Domain Copyright and Patent.

Electrical Generator

A 26,000 Watt Gasoline Engine powered Electrical Generator can be constructed by coupling a side shaft gasoline engine to a generator head. This Electrical Generator puts out electricity using one 220 Volt 30 amps outlet and two 125 Volt 15 amp outlets for a combined output of 440 Volts at 60 amps, more or less.

Perpetual (C)Copyright and (P)Patent (2011C.E.) by Anthony J. Fejfar and Neothomism, P.C. (PA).